Dynamips is a Cisco router emulator. Supported platforms are 1700, 2600, 3600, 3700 and 7200 routers. Each IOS has an associated Idle PC value. Idle PC is used to map the idle instruction of the running IOS to the idle instruction of the UNetLab platform. With a good Idle PC value, the CPU usage should be less than 10% for each instance. Show Eve-ng is a platform where you can add Cisco routers images and can do unlimited practice for your certification. In Eve-ng you can practice lab up to CCIE level We will tell you step by step process of How to add Cisco IOS images to EVE-ng Content- if you want to practice Cisco ASA / IOU/ IOL on eve-ng for your certification or knowledge then check below posts- How to add Cisco IOU/IOL to Eve-ng How to add Cisco ASAv to Eve-ng 1. SUPPORTED DYNAMIPS IMAGES
2. Download Cisco IOS (Dynamips images) Eve-ngImages provided below are strictly for education purpose and are not hosted on networkhunt.com server. We are just indexing the links find on internet for education purpose only. You can download Cisco IOS (dynamips images) from below links. If you are uploading the zip file then install the required package- Install required packages: Upload the downloaded image to the Eve-ng master node using for example FileZilla or WinSCP. Then login as root using SSH protocol and uncompress it: Create tmp directory Using EVE CLI, uncompress original image. Output file extension must be .image. Be sure you are using properly your source and output filenames.
Move uncompressed image to destination folder: 4. CALCULATING IDLE PCIf an unsupported image is added to the UNetLab platform, an Idle PC value must be identified. Start a Dynamips instance with basic configuration:
CPU usage is very high, a whole CPU for each instance:
Wait for the following line on the console:
Exit from initial configuration dialog, and quit to get the con0 prompt:
After few more seconds press
Select one and restart dynamips with the IDle PC value:
If CPU usage is lower, then a good Idle PC value has been found:
Usually the highest value of IDLE PC will best for your CPU. In the calculation above it is 76. Copy value of IDLE PC to the notepad and we can start test best value fit for your Dynamips node. To stop dynamips router calculation mode use: Key combo CTRL and ] then q Go to EVE WEB GUI, add your Dynamips node and change IDLE PC value to calculated, save and start node. Check your CPU with top command (cpu check section above) If CPU usage is lower, then a good IDLE PC value has been found: PID USER PR NI VIRT RES SHR S %CPU %MEM TIME+ COMMAND 3598 root 20 0 346700 125328 109828 S 5.3 25.3 0:03.98 dynamips If CPU is still high, then another value must be tested. What is Cisco image?Cisco Image Types
A boot image (also referred to as the xboot, rxboot, bootstrap, or bootloader) and the system image (the complete IOS image). The boot image is a subset of the Cisco IOS software that is used when network booting when loading IOS images onto a device or when the system image has been corrupted.
What is the name of the Cisco IOS image file?Cisco IOS (Internetwork Operating System) image file is normally stored in flash memory and it has a naming convention. Following output shows the "show-flash" command from privileged mode. The name of the Cisco IOS (Internetwork Operating System) file is c2600-i-mz.
Where can I download images for Eve Ng?Simply you should connect to the eve-ng with Filezilla and go to the same directory where all the images are located, and download them to your computer.
What is Cisco Dynamips?Dynamips is an emulator computer program that was written to emulate Cisco routers. It was developed by Christophe Fillot, who began working on it in August 2005. Dynamips runs on FreeBSD, Linux, Mac OS X and Windows.
|